The use of a brush cutter is mainly in cutting weeds and small shrubs in the new garden site, for the tractor into the garden plowing, and for land preparation work, but also for the construction of the garden to provide the service of cutting weeds. How to use the brushcutter, to pay attention to the matters and what is it? The following is a detailed explanation for you.

Operation points of the Senwart brush cutter.

①  After the engine of the backpack-type brushcutter is started, the backpack will be carried on the operator's back, the engine power will be transmitted to the working parts of the brushcutter through the flexible shaft, and the operator, holding the lever in his hand, can cut while walking. Because the engine is carried on the back, operating flexibility, not affected by the terrain and slope, can be up and down, left and right free operation, especially adapted to the complex terrain of the mountainous areas of the mowing and irrigation operations.

②  Side-mounted brushcutter engine start, it is hung by the side with the operator's shoulder, when the engine speed reaches 2800-3200r/min, the centrifugal clutch combined, the hard sleeve drive shaft rotation, the operator holds the handle while walking and cutting, the operation of the site of the small bushes and weeds cut and remove the operation of the width of about 1 meter.

③  Cutting 8 cm below the shrubs can be used one-way into the saw directly into the way; cutting more than 8 cm shrubs, trees can be used two-way into the saw, that is, the first saw the lower mouth, after sawing the upper mouth, the saw in the saw is strictly prohibited when the impact of cutting, otherwise due to the inertia of the action will be hurt or damage to the machine parts.

④  After starting or during the operation of the brushcutter with a saw blade or cutter plate installed, other than the operator, other people must be 3 meters away from the machine.

 ⑤  When moving to a new working point, close the throttle and stop the working parts, then increase the throttle and speed to the new working point, and then carry out the cutting operation. (6) When stopping the machine, you should close the throttle and idle for 3-5 minutes before stopping the machine, and it is forbidden to stop the machine suddenly in high-speed operation.

The use of brushcutter must pay attention to.

①  Engine use precautions: add qualified gasoline and gasoline engine oil, gasoline and oil mixing ratio of 25:1; 25 hours after the operation must check the air filter and spark plugs; each work tank should be rested for ten minutes; every shift should be cleaned up after the operation of the heat sink dirt to ensure that its heat dissipation effect.

②  Precautions for the use of transmission parts: twenty-five hours after the operation of the gearbox to replenish the grease, while the upper part of the drive shaft and the clutch combination of grease.

③ tool use precautions: the use of saw blades, and blades, should be balanced, and sharp, do not use vibration saw blades, or blades; weeding nylon rope, the use of length should be controlled at less than or equal to 15cm.